2pcs New TI OPA1622 Dual Op Amp Low Distortion 145ma High Current Patch to DIP8
$20.79
In stock
SKU
eii10629
2pcs New TI OPA1622 Dual Op Amp Low Distortion 145ma High Current Patch to DIP8
Parameter:
Brand: Texas Instruments / TI Burr Brown
Origin: Thailand
Model: OPA2604AP Low Distortion Low Noise Bipolar Input High Performance Audio Operational Amplifier
Specifications: DIP8 double-column and eight-pin in-line (since the original chip op amp pins are small, we have soldered the in-line conversion board)
Voltage: ±2V to ±18V
Distortion: –119dB (142mW/channel to 32Ω/channel)
Noise: 2.8nV/√Hz at 1kHz
Rate: 10V/μs
Bandwidth: 32MHz (G = +1000)
Rated temperature: –40°C to +125°C.
Features:
* Dual channel, bipolar input, SoundPlusTM audio op amp.
* Ultra-low noise density of 2.8nV/√Hz and ultra-low THD+N of –119.2dB at 1kHz, while also driving a 32Ω load with output power of 100mW.
* High AC Power Supply Rejection Ratio (PSRR) and Common Mode Rejection Ratio (CMRR) specifications to eliminate noise from power supplies for portable audio applications.
* Also has a high output drive capability of +145mA/–130mA.
* Supports a wide supply voltage range of ±2V to ±18V with a supply current of only 2.6mA per channel.
* Unity gain is stable
*With shutdown mode
* Internally uses a unique layout to achieve minimum crosstalk and zero interaction between channels even under overdrive or overload conditions.\
P.S.:
*Replacing the op amp requires a certain amount of electronic knowledge, hands-on ability, and risk. The op amp has been instrument tested and auditioned;
* In any case, the wrong connection of the pins and electrostatic breakdown may cause irreversible damage;
* Do not use the heat gun when soldering the op amp. The soldering iron soldering temperature should be lower than 300 degrees, otherwise the chip will be damaged;
* The op amp can be taken out of the package before soldering, using a soldering iron or anti-static soldering station with a solid grounding;
* Wear pure cotton clothing for welding operations or wear anti-static clothing;
* Wear anti-static bracelets and gloves! There is no copper wire that can be used for simple protection. The other end of the copper wire is wrapped around the wrist, and both hands should be used to reduce the possibility of accidental electric shock.
Quantity:
2pcs
Warranty:
90 days after receipt of order
Write Your Own Review